Getting Started
DKIT-04 Dimmer Starter Kit
Simply Automated, Incorporated
Section 2: Installation of the Dimmers and I/O Module
Section 2.a. Installation of the Dimmers
Locate two switches in your home (i.e. master bedroom, front door, garage entry, or outdoor
porch) that turn on/off the lights you would like to control with your security panel and the I/O
Module. Replace these switches with the Simply Automated Dimmers. To install the dimmers
please refer to the User Guide in the boxes the dimmers came packaged in. Or see
http://simply-
automated.com/documents/452-0051-0101_RevD_US11-40_UserGuide_090512.pdf for
installation instructions.
All Simply Automated dimmers operate just like a regular dimmer. Test each dimmer to ensure
they are properly installed. Press (tap) the top of each rocker to turn on the circuit. Press (tap)
the bottom of the rocker to turn off the circuit.
The dimmers have been programmed from the factory to turn on at 100%. If you would like a
different lighting level when the light is off, press and hold the top of the rocker until the desired
level is achieved. If you would like a different lighting level when the light is on, press and hold
the bottom of the rocker until the desired dim level is achieved, then release. If you are using
compact florescent or florescent lighting, you should not attempt to change the dimming level.
Florescent lighting cannot be dimmed, can only be turned on at a 100% dim level.
Important note: each dimmer has a specific device ID #. You can find the device ID # on the
box the dimmer came packaged in and also on the front of each dimmer. One dimmer has
device ID #16 and the other has device ID #17. This is important information, it relates to
operation with the Input/Output Module and Pocket Programmer (sold separately).
Section 2.b. Installation of the I/O Module
Locate a 110 VAC power receptacle in (or near) the alarm panel and plug-in the I/O Module. The
I/O Module has 3 pre-configured inputs (3 low voltage 4-5VAC/DC or 2 contact closure) to turn
on/off the 2 dimmers. Refer to User Guide in box the I/O Module came packaged in or see
http://simply-automated.com/documents/452-0003-0001_RevE_UMI_UserGuide_090512.pdf.
The discrete low voltage or contact closure trigger outputs of the security panel need to be
connected to the proper terminals of the I/O Module.
Input 1: Low Voltage (only), terminals 6 and 7
Turns on/off first dimmer (#16)
Input 2: Contact, terminals 9 and 10
OR
Input 2: Low Voltage, terminals 8 and 9
Turns blinking on/off for all dimmers
Input 3: Contact, terminals 15 and 16
OR
Input 3: Low Voltage, terminals 14 and 15
Turns on/off all dimmers
Note: Low voltage inputs are differential (i.e.
positive or negative polarity does not matter).
6108 Avenida Encinas, Suite B, Carlsbad, CA 92011 USA
Technical Support: www.simply-automated.com
or 800-630-9234
452-00004-1001 Rev. B Revised: July 7, 2009
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji